Use only standard compliant cabling to connect cisco prestandard ip phones and wireless access points or ieee 802 3af compliant devices.
Cisco 2960x stack cable connection.
A switch stack is a set of up to eight stacking capable switches connected through their stack ports.
If the cable is bad replace it with a known good cable.
Cisco 2960x stack configuration.
Applies to the catalyst 2960x 24psq l switches.
I have to configure this switch.
Hello i am connecting 2 ws c2960s 48fps l.
You must remove any cable or device that causes a poe fault.
Start a terminal emulation program on the pc.
I found documentation for connecting 3 or more switches for maximum redundency but nothing for only 2 switches.
The c2960x stack is a catalyst 2960 x series flexstack plus stacking module.
Configure the pc terminal emulation software for 9600 baud 8 data bits no parity 1 stop bit and no flow control.
This is only supported on the stack capable switches.
Figure 1 17 connect the flexstack cables.
Connect an usb cable to the pc usb port.
Connect the other end of the cable to the mini b 5 pin connector usb port on the switch.
A connect master stack port 1 member stack port 1 master stack port 2 member stack port 2 or b conn.
Insert the other end of the cable into the stack port on the other switch.
The stack can have one of these configurations.
Yes you make a single logical switch when you connect switches using stack cable.
Make sure you insert the cables in completely until you feel them snap into place.
Always use a cisco approved flexstack cable to connect the switches.
Step 2 insert one end of the flexstack cable into the stack port of the first switch.
Hi folks am into cisco contact center deployment world and now first time i came with new model of cisco 2960x flexstack switch 48port and 24port.
You can connect only one switch type in a stack or you can connect a mix of catalyst 2960 x and catalyst 2960 s switches in the stack.
It connects up to eight cisco 2960 x series switches in a stack that functions as a single local switch.
Remove and inspect the stack cable and stack port for bent pins or damaged connectors.
Highlights flexstack plus is the name of the stacking technology used by the cisco catalyst 2960 x and 2960 xr series.
When you connect the flexstack cable to the stack 1 port the tab should be above the connector.
